Panasonic AJ-SPX800E Benutzerhandbuch

If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING lamp, 
lamps inside the viewfinder and a warning tone. 

The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors occur 
simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated, depending on the 
menu setting. 

The error code lights up.

Blinks 4 times per second. 

Blinks 4 times per second. 

The SYSTEM ERROR indication and the error
code light up. 

Beeps continuously. 

An error in the reference signal or the
communication. 

The operation stops. 

Please confirm [7-3-2 Error Codes] and consult
your nearest service centre. 

All 7 bar indicators for battery remaining capacity
start blinking. 

Lights up. 

Blinks once per second. 

The BATT LED lights up. 

Beeps continuously. 

The battery has run out. 

The operation stops. 

Replace the battery. 

Error code E-30 appears.

Blinks 4 times per second.

Blinks 4 times per second.

The “TURN POWER OFF” indicator blinks.

Continues to beep.

The P2 card being accessed has been removed,
resulting in an error in the internal memory of the
camera-recorder.

Cannot be performed.

Turn off the power to the camera-recorder. If
there is an error in a clip on the removed P2 card,
repair the clip.

All 7 bar indicators for remaining MEDIA capacity
start blinking. 

Continues to light up until an operation is
performed. 

Continues to blink 4 times per second until an
operation is performed. 

The WP indicator blinks. 

Continues to beep until an operation is
performed. 

The inserted P2 cards are write-protected. 

Recording is disabled. 

Disable the write-protect or replace the P2 card.