Panasonic cy-vmd9000u Benutzerhandbuch
E
N
N
G
L
I
S
H
H
52
CY-VMD9000U
67
E
N
N
G
L
I
S
H
H
51
CY-VMD9000U
66
Installation Guide
(Continued)
❐ Installation Procedures
(When using mounting collar 2)
(a) Using the rear support strap 9
Drill a hole 6.5 to 7 mm in diameter.
9 Rear support strap
7 Washer assem-
bling hex. bolt
(M5a10 mm)*
(M5a10 mm)*
1
6 Flange nut (M6)
Fire wall
of car
of car
(b) Using the rubber pad 4
5 Mounting bolt (M5)
Bracket (on car)
Display unit
4 Rubber pad
8 Washer assembling
hex. bolt (M6a20 mm)
Use the brackets supplied with your car when mounting this unit. The bracket shape and mounting method
vary with car manufactures, car types and manufacturing year.
Please consult your nearest your nearest Panasonic Servicenter for details.
vary with car manufactures, car types and manufacturing year.
Please consult your nearest your nearest Panasonic Servicenter for details.
Select mounting screws according to the hole positions and hole shape of the bracket.
: Binding-head screw (M5k6 mm)
2 pieces
Recycle the binding-head screws that fixed the transportation brackets for
two more positions.
Recycle the binding-head screws that fixed the transportation brackets for
two more positions.
; Flat-head screw (M5k6 mm)
3 Mounting spring
5 Mounting bolt (M5)
C
@ Power connector
Display unit/control unit
connecting cord
connecting cord
Tab
Tab
Dashboard
Mounting collar
2
Fastening the mounting collar
The tabs to be bent vary depending on the car.
Bend them with a screwdriver to fasten the
mounting collar 2 securely in the dashboard.
The tabs to be bent vary depending on the car.
Bend them with a screwdriver to fasten the
mounting collar 2 securely in the dashboard.
❐ Installation Procedures
(When not using mounting collar 2)
< Binding-head screw (M4k3 mm)
4 pieces
; Flat-head screw (M5k6 mm)
4 pieces
When using these mounting holes
Insert mounting collar 2 into the dashboard,
and bend the mounting tabs out with a screw-
driver.
and bend the mounting tabs out with a screw-
driver.
1
Insert trim plate 1.
After installation, reconnect the negative - bat-
tery terminal.
tery terminal.
4
5
Attach the mounting springs 3 to the display
unit.
unit.
2
Secure the rear of the unit.
After fixing power connector @ and display
unit/control unit connecting cord C, fix the rear of
the unit to the car body by either method (a) or (b)
shown at right.
After fixing power connector @ and display
unit/control unit connecting cord C, fix the rear of
the unit to the car body by either method (a) or (b)
shown at right.
3
Display unit
Side of the display unit
Note:
≥
≥
The car model, installation conditions and
combination of the units used may impose
some restrictions on opening and closing the
monitor as well as on the angle and position
to which the monitor can be adjusted.
combination of the units used may impose
some restrictions on opening and closing the
monitor as well as on the angle and position
to which the monitor can be adjusted.
*
1
Use M5a8 mm size bolts (optional) if bolts other than the supplied ones are to be used.