Panasonic kx-tcd240fx Benutzerhandbuch
Preparation
13
the batteries have been charged for at
least 15 minutes.
least 15 minutes.
L
If the handset is turned off, it will be turned
on automatically when it is placed on the
base unit.
on automatically when it is placed on the
base unit.
Battery life
After your Panasonic batteries are fully
charged, you can expect the following
performance:
Ni-MH batteries (700 mAh)
After your Panasonic batteries are fully
charged, you can expect the following
performance:
Ni-MH batteries (700 mAh)
Note:
L
Actual battery performance depends on a
combination of how often the handset is in
use (talking) and how often it is not in use
(standby).
combination of how often the handset is in
use (talking) and how often it is not in use
(standby).
L
Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
over time depending on usage conditions
and ambient temperature.
Battery replacement
If 7 flashes even after the handset
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
L
We recommend the use of Panasonic
rechargeable batteries noted on page 6. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
rechargeable batteries noted on page 6. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
L
Do not mix old and new batteries.
1
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
firmly and slide it in the direction of the
arrow.
2
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 12 for battery installation.
terminal first and install the new ones.
See page 12 for battery installation.
Turning the power on/off
Power on
Press {ih} for about 1 second.
L
The display will change to the standby
mode.
mode.
Power off
Press {ih} for about 2 seconds.
L
The display will go blank.
Setting dialling mode
(tone/pulse)
(tone/pulse)
Change the dialling mode depending on
your telephone line service.
“Tone”: Select when you have a touch tone
service.
“Pulse”: Select when you have rotary or
pulse service.
your telephone line service.
“Tone”: Select when you have a touch tone
service.
“Pulse”: Select when you have rotary or
pulse service.
1
Press {j/OK}.
2
Select “Base Unit Setup”, then
press {>}.
press {>}.
3
Enter “0000” (default base unit PIN).
Operation
Operating time
While in use (talking)
20 hours max.
While not in use
(standby)
(standby)
170 hours max.
TCD230-240FX(e).book Page 13 Wednesday, June 8, 2005 7:15 PM