Panasonic kx-tcd340 Benutzerhandbuch
Preparation
15
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Battery replacement
If 3 flashes even after the handset
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
L
We recommend the use of Panasonic
rechargeable batteries noted on page 6. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
rechargeable batteries noted on page 6. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
L
Do not mix old and new batteries.
1
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
firmly and slide it in the direction of the
arrow.
2
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 13 for battery installation.
terminal first and install the new ones.
See page 13 for battery installation.
Turning the power on/off
Power on
Press {ih} for about 1 second.
L
The display will change to the standby
mode.
mode.
Power off
Press {ih} for about 2 seconds.
L
The display will go blank.
Setting the date and time
Important:
L
Confirm that the AC adaptor is connected.
L
Ensure that w is not flashing. If the
handset is in screen saver mode, w is not
displayed. Press {ih} to turn the
display on.
handset is in screen saver mode, w is not
displayed. Press {ih} to turn the
display on.
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select “Time Settings”, then press
,
,
.
4
Select “Set Date & Time”, then press
,
,
.
5
Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
6
Enter the current hour and minute by
selecting 2 digits for each.
selecting 2 digits for each.
L
You can select “AM”, “PM” or 24-hour
time entry by pressing {*} repeatedly.
time entry by pressing {*} repeatedly.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press {*}
repeatedly until “03:30 PM” is
displayed.
Press {0}{3} {3}{0}, then press {*}
repeatedly until “03:30 PM” is
displayed.
7
Press ,.
8
Press {ih}.
Note:
L
To correct a digit, press {<} or {>} to
move the cursor, then make the
correction.
move the cursor, then make the
correction.
L
The date and time may be incorrect after a
power failure. In this case, set the date
and time again.
power failure. In this case, set the date
and time again.
TCD340E(e).book Page 15 Thursday, June 9, 2005 9:50 AM