Panasonic kx-tcd965 Benutzerhandbuch
74
Replacing the Batteries
•
Discard defective batteries as soon as possible. Defective batteries may leak into the unit.
•
Please use only Panasonic P-03H or P-P03S batteries.
•
If the rechargeable batteries are not inserted correctly, the handset will not work.
•
At the end of its useful life, the Nickel-Cadmium battery must be disposed of properly.
•
Nickel metal hydride (Ni-MH) rechargeable batteries (AAA size) are available.
Please use only Panasonic HHR-P03H batteries.
Please use only Panasonic HHR-P03H batteries.
Battery replacement
If “
” flashes after a few telephone calls even when the handset batteries have been fully
charged, it is time to replace the batteries with new ones. Remember to charge the new
batteries after replacement.
batteries after replacement.
1
Turn the power OFF to prevent memory loss (p. 14).
Remove the cover by sliding while pressing in the
direction of the arrow, then take out the batteries.
Remove the cover by sliding while pressing in the
direction of the arrow, then take out the batteries.
2
Replace the batteries with new ones as shown.
•
When you finish, close the handset cover
and turn the power ON (p. 14).
and turn the power ON (p. 14).
3
Be sure to charge the new batteries fully in order to
display the battery icon correctly (p. 13).
display the battery icon correctly (p. 13).
Ni-Cd battery: For about 4 hours
Ni-MH battery: For about 8 hours
Ni-MH battery: For about 8 hours
Selecting the battery type
Three Nickel cadmium (Ni-Cd) batteries are included with this unit. Nickel metal hydride (Ni-MH)
rechargeable batteries can also be used. If you replace the batteries with Ni-MH batteries, you must
set the battery type selection to “
rechargeable batteries can also be used. If you replace the batteries with Ni-MH batteries, you must
set the battery type selection to “
Ni-MH
”, or the battery strength will not be displayed correctly. The
factory preset is “
Ni-Cd
”.
1
Press .
2
Press
G or F until the arrow points to “
Program
”, then press OK
H.
3
Press
G or F until the arrow points to “
Display Option
”, then press OK
H.
4
Press
G or F until the arrow points to “
Battery Type
”, then press OK
H.
•
The current battery type is at the arrow.
5
Press
G or F to select “
Ni-Cd
” or “
Ni-MH
”, then press OK
H.
•
The display will return to the “
Battery Type
”. To return to the stand-by mode, press
or
wait for 60 seconds.
•
Incorrect battery type selection may shorten battery life.
C
F
KX-TCD965EC-6(74~84) 99.12.10 5:44 PM Page 74