Panasonic nv-gs15ege Benutzerhandbuch

Seite von 62
Before Use
-9-
≥Make sure to match the poles correctly when 
inserting the battery.
ª Using the Remote Controller
1
Direct the Remote Controller at the Remote 
Control Sensor 
(31)
 of the Movie Camera 
and press an appropriate button.
≥Distance from the Movie Camera: Within 
approximately 5 metres
≥Angle: Within approximately 15o in the 
vertical and horizontal directions from the 
central axis
≥The above operating ranges are for indoor use. 
Outdoors or under strong light, the Movie 
Camera may not operate properly even within 
the above ranges.
Selecting Remote Controller Modes
When 2 Movie Cameras are used 
simultaneously, they can be operated individually 
by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie 
Camera and that of the Remote Controller do 
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the 
desired Remote Controller Mode. (
-16-
)
CAUTION
Danger of explosion if battery is 
incorrectly replaced. Replace only 
with the same or equivalent type 
recommended by the equipment 
manufacturer. Discard used batteries 
according to manufacturer’s 
instructions.
WARNING
Risk of fire, explosion and burns. Do 
not recharge, disassemble, heat 
above 100
xC or incinerate. Keep the 
Button-Type battery out of the reach 
of children. Never put Button-Type 
battery in mouth. If swallowed call 
your doctor.
15˚
15˚
15˚
15˚
(31)
Setup on the Remote Controller:
[VCR1]:
Press the [
D] Button and [∫] Button 
simultaneously. 
1
[VCR2]:
Press the [
E] Button and [∫] Button 
simultaneously. 
2
≥When the battery in the Remote Controller is 
replaced, the mode is automatically reset to 
[VCR1] Mode.
Power Supply
ª Using the AC Adaptor
1
Connect the DC Input Lead to the 
[DC/C.C.IN] Socket on the Movie Camera.
2
Connect the DC Input Lead to the AC 
Adaptor.
3
Connect the AC Mains Lead to the AC 
Adaptor and the AC mains socket.
≥The AC Mains Lead’s outlet plug does not fit 
entirely into the AC Adaptor socket. A gap will 
remain as shown 
1.
Before connecting or disconnecting the 
power supply, set the [OFF/ON] Switch on 
the Movie Camera to [OFF] and make sure 
that Power Lamp is not lit.
INDEX
INDEX
SELECT
STOP
K
L
STILL ADV
T
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
1
1
2
3
15EGE-ENG.book  9 ページ  2004年2月9日 月曜日 午前11時10分