Panasonic p2hd ag-hpg20 Benutzerhandbuch

Seite von 120
Charging the battery
0
Charging
The battery has not been charged at the time of 
purchase.
Before using the battery, give it a full charge using 
the AC adapter. It is recommended that you have a 
spare battery available in case you need it.
Place the battery horizontally while aligning 
it with the   mark on the AC adapter, and 
slide it into position.
If the DC cord is connected to the AC adapter, 
disconnect it before proceeding any further. 
The battery cannot be charged if this cable is 
left connected.
 
Connect the AC cable to the power outlet.
The POWER and CHARGE lamps on the AC 
adapter light, and charging starts.
If the CHARGE lamp fails to light when the 
battery has been installed, remove the battery 
and then re-install it.
POWER
CHARGE
When the battery has been charged, the 
CHARGE lamp on the AC adapter goes off.
Depending on the country and region, the 
actual configuration of the power cord, plug, 
and power outlet may differ from those shown 
in these operating instructions.
 
Slide the battery out of position, and remove it.
 
Charging time and play time of supplied battery
Capacity
Charging 
time
Continuous 
playback time
5400 mAh
Approx. 330 
minutes
Approx. 230 
minutes
The times given in the above table are 
approximate figures based on playback in the 
AVC-Intra100 mode.
The times given in the above table are obtained 
at an ambient operating temperature of 20 °C (68 
°F) and an ambient relative humidity of 60 %. It 
may take longer to charge the battery at other 
temperature and humidity levels.
While the battery is being used or charged, it will 
become hot.
If the playback and stop operations are repeated 
more than necessary, the playback time will be 
shorter than the time given in the above table.
When the battery is to be stored for a prolonged 
period, it is recommended that you charge it once 
a year, use the battery in the unit until its charge 
is used up, and then return it to storage.
When the battery temperature becomes 
extremely high or low or when a discharged 
battery has been left unused for a prolonged 
time, the CHARGE lamp will blink several times, 
and charging will commence automatically.
When the CHARGE lamp continues to blink even 
when the battery is at the right temperature, 
it may indicate a failure in the battery or AC 
adapter. Contact your dealer.
When the battery is warm, it will take longer than 
usual to recharge it.
When the AC adapter is used near a radio, the 
sound from the radio may be distorted. Use the 
AC adapter and radio at a distance of at least 1 
meter from each other.
Noise may be heard from the AC adapter while 
the AC adapter is being used: this is normal and 
not a sign of trouble.
The battery cannot be charged when power is 
supplied to the unit from the AC adapter.
No guarantees are given for the operation of the 
CGR-D16/CGR-D16s (1600 mAh) battery pack.