Panasonic pv-gs200 Benutzerhandbuch

Before Use

Selecting Remote Controller Modes
When 2 Camcorders are used simultaneously, 
they can be operated individually by selecting 
different Remote Controller Modes.
≥If the Remote Controller Mode of the 

Camcorder and that of the Remote Controller 
do not match, [REMOTE] Indication is 
displayed.

Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the 
desired Remote Controller Mode. (

)

[VCR1]: Press the [

D] Button and [∫] Button 

simultaneously. 

1

[VCR2]: Press the [

E] Button and [∫] Button 

simultaneously. 

2

≥When the battery in the Remote Controller is 

replaced, the mode is automatically reset to 
[VCR1] Mode.

ª Using the AC Adaptor

Connect the AC Cable to the AC Adaptor 
and the AC Jack.
≥The AC Cable’s outlet plug does not fit 

entirely into the AC Adaptor jack. A gap will 
remain as shown 

1.

≥Before connecting or disconnecting the 

SELECT

K

L

∫

6

1

5

;

E

D

P.B. ZOOM

2

1

1

ª Using the Battery

Before use, fully charge the Battery.
≥We recommend using a Panasonic Battery.
≥We cannot guarantee the quality of this 

Camcorder when batteries from other 
companies are used.

≥Since the Battery will not be charged when 

the DC Cable is connected to the AC 
Adaptor, disconnect it from the AC Adaptor.

≥The [CHARGE] Lamp lights up, and charging 

starts.

≥When the [CHARGE] Lamp goes off, 

charging is completed.

≥When the battery is completely discharged, 

the [CHARGE] lamp blinks at first, but the 
battery is charged normally. When the 
temperature of the battery is too high or low, 
the [CHARGE] lamp blinks and the charging 
time becomes longer than usual.

Disconnecting the Power Source
Set the [OFF/ON] Switch 

 to [OFF] and, while 

pressing the [PUSH BATT] Button 

, slide the 

Battery or DC Cable upward to disconnect it.

≥For other notes concerning this item, see 

.

PUSH

BATT

ON

OFF

PV-GS120_200Eng.book  16 ページ  ２００４年２月１６日　月曜日　午後１時３２分