Panasonic rf-d7 Benutzerhandbuch

Seite von 8
Listening to sound via earphone 
(not included)
4
FM Radio operations
Press .
To turn the unit off, press the button again.
1. Turn on the unit’s power.
When the power is turned on again,
the broadcast station that was last
tuned in when the power was turned
off, will be tuned in.
Standby/on switch (
)
Press to switch the unit from on to standby
mode or vice versa.
In standby mode, the unit is still consuming a
small amount of power.
Note
Turn 
to select the desired station.
Automatic tuning
When 
is press and hold, automatic tuning starts, and it stops at the station which is tuned in
first. Repeat this until the station you want to listen to is tuned in.
2. Select the broadcast station.
Depending on the quality of the reception, automatic tuning may not be possible.
• During tuning press 
to stop.
Note
Turn 
to adjust the volume. (0 to 50)
3. Adjust the volume.
F M     8 7 . 5 0 M H z
T U N E D
V O L U M E     2 8
Turn the volume down before connecting the
earphone.
Plug type: 
Ø3.5 mm monaural mini plug
Avoid listening for prolonged periods
of time to prevent hearing damage.
Note
Making it easier to understand what’s
being said (RF-D7 only)
Preset tuning   
A total of 10 FM stations can be preset.
Specifications
• Frequency range
FM
87.50-108.00 MHz (50 kHz steps)
DAB BANDIII
5A-13F (174.928-239.200 MHz)
(For the United Kingdom)
11B-12D (218.640-229.072 MHz)
• Terminals
Output   PHONES
Ø3.5 mm monaural (8-16 Ω)
• Power output
1 W (RMS)
• Power supply
AC 230-240 V, 50 Hz
Battery
DC 9 V (Six R14/LR14, batteries)
• Battery life
DAB: About 25 hours
(Panasonic alkaline battery)
FM: About 50 hours
• Power consumption
7 W (RF-D5EB)
9 W (RF-D7EB)
• Speakers
Full range
10 cm, 8 Ω
× 1
• Dimensions (W × × D)
270 mm × 152 mm × 92.5 mm
• Mass
With batteries
Approx. 1.67 kg
Without batteries
Approx. 1.26 kg
Power consumption in standby mode: 1 W 
Specifications are subject to change without notice.
To improve reception
Adjust the length and angle of the rod antenna to obtain
the best reception.
If you take hold of the unit’s rod antenna and move it
from one place to another, you may damage the unit.
To move the unit, make sure you pick it up by
the handle on the rear panel, and then move it.
Handle
Note
The illustrations 
show RF-D7.
“TUNED” appears for about 1 second
when a station is tuned in.
Preset stations
While listening to the station you want to register, hold down one of the
number buttons [1] to [5] for at least 1 second. The number of the button
you pressed and “PROGRAM” now appear on the display panel, and the
station is registered in the button concerned.
Example: When you registered a station in
button [1]
• To register a station greater than 5, first press [5+], then, e.g. to register 7
(within 10 seconds) press and hold [2].
Listening to a station which you have registered
After the power has been turned on, press the number button in which the
desired station has been registered. (To listen to, e.g., station 7, press [5+],
then press [2].) The station will then be tuned in.
Changing a station which you have registered
With the new station you want to register already tuned in, press and hold
the button with the number whose registered station is to be changed so
that you will overwrite the existing station with the new one.
F M     8 7 . 5 0 M H z
M   1   :   P R O G R A M
You can adjust the speed of what’s being said to understand newscasts, the
dialogue of characters in dramas, etc. better.
Press .
• The indicator around 
now lights.
• To close the slow speech function, press the button again. (The
indicator around 
now goes off.)
• When the slow speech function is activated, the sound
quality will automatically be switched to NORMAL and
cannot be changed.
• The slow speech function effects may not be obtained with some
music programs and other broadcast content.
• The slow speech function is released in the following cases:
(1) When the power is turned off
(2) When you have changed the station you are now listening to
• When the slow speech function is set to ON, the tone quality
will change, and there will be a delay in the sound heard.
• The speed of the slow speech function cannot be changed.
• When the slow speech function is set to ON while the
reception is poor and accompanied by a lot of noise, the
noise will be amplified, making the sound hard to listen to.
At a time like this, set the function to OFF.
Note
RF-D7_5-0205    07.2.5  2:49 PM    ページ 4