Panasonic sc-pm91d Benutzerhandbuch
31
RQT7937
Enjoying more powerful bass
• Connect an active subwoofer (not included).
• Place the subwoofer as close as possible to the front center.
Adjusting the bass
Press [SHIFT] + [SUBWOOFER].
Every time you do this:
SUB.W ON SUB.W OFF
Adjust the volume on the subwoofer to suit your preference.
SUB.W ON SUB.W OFF
Adjust the volume on the subwoofer to suit your preference.
Using other equipment
Other antenna connections
Use outdoor antennas if radio reception is poor.
FM outdoor antenna (using a television antenna)
• Disconnect the FM indoor antenna.
• The antenna should be installed by a competent technician.
Disconnect the outdoor antenna when the unit is not in use.
Do not use the outdoor antenna during a lightning storm.
Do not use the outdoor antenna during a lightning storm.
AM outdoor antenna
• Run a piece of vinyl wire horizontally across a window or other
convenient location.
• Leave the loop antenna connected.
AM ANT
FM ANT
OPTICAL
OUT
S-VIDEO
HAUT-PARLEURS
OUT
VIDEO
OUT
SUBWOOFER
OUT
R
L
AUX
HIGH (6
Ω) LOW (6Ω)
SPEAKERS (SB-PM91D)
R
L
EXT
LOOP
75
Ω
IN
AV
Audio cable
To the
subwoofer's
input terminal
FM ANT
75
FM outdoor antenna
75 Ω coaxial cable
AM loop
antenna
(included)
antenna
(included)
AM outdoor antenna
5-12m
Using other equipment
Changing the remote control code
Change the code if you find the remote control unintentionally also
controls other equipment.
controls other equipment.
1
Change the main unit’s code.
①
Press [TUNER/AUX] to select “AUX”.
②
Press and hold [TUNER/AUX] on the main unit and then press
and hold [2] (or [1]) on the remote control.
and hold [2] (or [1]) on the remote control.
“REMOTE 2” appears on the display.
2
Change the remote control’s code.
Press and hold [ENTER] and [2] (or [1]) on the remote control for
at least 2 seconds.
If the remote control and main unit are using different codes, a message
appears on the main unit’s display showing the main unit’s current code.
Follow step 2 to change the remote control’s code to match it.
appears on the main unit’s display showing the main unit’s current code.
Follow step 2 to change the remote control’s code to match it.
Note
SC-PM91D EB.indd 31
3/18/2005 2:18:56 PM