Panasonic sdr-s100pp Benutzerhandbuch
99
VQT0T50
Problem
Check points
Recording does not
start although power is
supplied to this unit and
the SD card is correctly
inserted.
start although power is
supplied to this unit and
the SD card is correctly
inserted.
≥ Has the SD card’s write protect switch been set to
[LOCK]?
> No recording is possible while the write protect switch is
> No recording is possible while the write protect switch is
set to [LOCK]. (P15)
≥ Is the SD card’s memory full?
> If the card has no more available memory, free up some
memory by copying some scenes to a PC (P80) and then
deleting unnecessary scenes. (P62)
deleting unnecessary scenes. (P62)
≥ Is the unit set to the motion picture recording mode or
still picture recording mode?
> No recording is possible unless the mode dial is at
> No recording is possible unless the mode dial is at
or .
(P20)
≥ Is the card cover open?
>
If the cover is open, this unit may not operate
normally. Close the card cover.
normally. Close the card cover.
(P14)
Motion picture
recording stops
suddenly.
recording stops
suddenly.
≥ Can the SD card be used for motion picture recording?
> Use an SD card that can be used for motion picture
recording. (P34, 35)
Auto focus function
does not work.
does not work.
≥ Is manual focus mode selected?
> If auto mode is selected, focus is automatically adjusted.
(P32)
≥ Are you trying to record a scene which is hard to bring
into focus in auto focus mode?
> There are some recording subjects and surroundings for
> There are some recording subjects and surroundings for
which the auto focus does not operate correctly. (P104) If
so, use the manual focus mode to adjust the focus. (P45)
so, use the manual focus mode to adjust the focus. (P45)
≥ Is the MagicPix set?
> When the MagicPix is working, focusing shifts into the
manual mode. (P45)
A sentence is displayed
in the screen center.
in the screen center.
≥ Read the contents and respond to them. (P93)
A function indication
such as mode
indication, remaining
time indication, or time
code indication is not
shown.
such as mode
indication, remaining
time indication, or time
code indication is not
shown.
≥ If you set [SETUP]
>[DISPLAY]>[OFF], indications
other than warnings and date indications disappear.
Sound is not played
back from the built-in
speaker of this unit.
back from the built-in
speaker of this unit.
≥ Is the volume too low?
> During playback, move the volume lever to display the
volume indication and adjust it. (P58)
VQT0T50_PP_ENG.book 99 ページ ２００５年８月３１日 水曜日 午後２時２５分