Panasonic th 103pf12u Benutzerhandbuch

Adjust the horizontal position.

Adjust the vertical position.

Adjust the horizontal size.

Adjust the vertical size.

(During “COMPONENT”, “RGB” and “PC” input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, 
adjust so that any such noise is minimized.

(During “COMPONENT”, “RGB” and “PC” input signal)
Eliminate the fl ickering and distortion.

Turn image over scan ON/OFF.
Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)

            ON                               OFF
Notes:
•  When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.
•  When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 56)

Notes:
•  If the dot clock frequency is 162 MHz or higher, DOT CLOCK and CLOCK PHASE cannot be made.
•  When digital RGB signal input, DOT CLOCK and CLOCK PHASE cannot be made.
•  AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright image 

with borders and other objects are clearly shown, and then try auto setup again.

• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out fi ne tuning for the 

position/size as required.

• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz, 

1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page 
52) may results in correct AUTO SETUP.

•  AUTO SETUP does not work well when a signal such as additional information is superimposed out of 

valid image period or intervals between synchronizing and image signals are short, or for image signal with 
tri-level synchronizing signal added.

• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION ( ) then adjust 

POS. /SIZE manually.