Panasonic th 42pd12u Benutzerhandbuch

Seite von 48
1
2
1
2
1
2
1
2
9
Connections
– Cable fi xing band
  Secure any excess cables with band as required.
Note:
Make sure that the AC cord 
is locked on both the left and 
right sides.
Push until 
the hook 
clicks.
2. Pull off.
1. Keep the 
 knob 
 pressed.
Close
Open
1
 
Plug the AC cord into 
the display unit.
 
Plug the AC cord until 
it clicks.
2
 
Fix the AC cord with 
the clamper which is 
attached to the unit.
 Note: 
  One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Speaker terminal (R, L)
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
AC cord 
connection 
(see page 13)
Pass the attached cable 
fi xing band through the clip 
as shown in the fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them 
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially 
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
To loosen:
Pull
Pull
Push the catch
–  AC cord fi xing
Unplug the AC cord
Unplug the AC 
cord pressing 
the two knobs.
Note: 
When disconnecting the AC cord, be 
absolutely sure to disconnect the AC 
cord plug at the socket outlet fi rst.
INPUT1: Video input terminal
INPUT2: S Video input terminal
INPUT3:  Component/RGB Video input terminals
Connect a video device such as VCR or DVD player. (see page 12)
From SERIAL 
terminal on 
computer
(see page 11)
From audio output terminal 
on external equipment 
connected to INPUT1 to 4 
(see page 10, 12)
INPUT4: PC input terminal 
From EXTERNAL monitor 
terminal on computer
(see page 10)