Panasonic th-50py70ey Benutzerhandbuch

•

Speci

fi cations

•

Frequently Asked 

Questions

AC 220-240 V, 50 / 60 Hz

486 W

561 W

0.5 W

16:9

106 cm (diagonal)

127 cm (diagonal)

922 mm (W) × 518 mm (H)

1,106 mm (W) × 622 mm (H)

2,073,600 (1,920 (W) × 1,080 (H)) [5,760 × 1,080 dots]

160 mm × 42 mm × 2 pcs, 8 Ω

20 W (10 W + 10 W), 10% THD

M3 (3.5 mm) stereo mini Jack × 1

VGA, SVGA, XGA

SXGA ······ (compressed)

Horizontal scanning frequency 31 - 69 kHz

Vertical scanning frequency 59 - 86 Hz

PAL I 

UHF E21-68 / VHF Ireland channel

PAL 525/60 

Playback of NTSC tape from some PAL Video recorders (VCR) or 

NTSC disc playback from DVD player and recorder.

M.NTSC 

Playback from M. NTSC Video recorders (VCR).

NTSC (AV input only) Playback from NTSC Video recorders (VCR).

VHF / UHF

Temperature  : 0 °C - 35 °C

Humidity 

: 20 % - 80 % RH (non-condensing)

21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, Q-Link)

21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)

RCA PIN Type × 1 

1.0 V[p-p] (75 Ω)

Mini DIN 4-pin 

Y:1.0 V[p-p] (75 Ω) C:0.286 V[p-p] (75 Ω)

AUDIO L - R RCA PIN Type × 2 

0.5 V[rms]

Y 

1.0 V[p-p] (including synchronization)

 ±0.35 

V[p-p]

AUDIO L - R RCA PIN Type × 2 

0.5 V[rms]

TYPE A Connectors 

• 

This TV supports “HDAVI Control 2” function.

HIGH-DENSITY D-SUB 15PIN 

R,G,B/0.7 V[p-p] (75 Ω)

 

HD, VD/TTL Level 2.0 - 5.0 V[p-p] (high impedance)

SD CARD slot × 1

AUDIO L - R RCA PIN Type × 2 

0.5 V[rms] (high impedance)

1,134 mm × 688 mm × 330 mm (With Pedestal)

1,134 mm × 641 mm × 116 mm (TV only)

1,323 mm × 802 mm × 369 mm (With Pedestal)

1,323 mm × 754 mm × 99.5 mm (TV only) 

42.0 k  Net (With Pedestal)

35.0 k  Net (TV only)

50.5 k  Net (With Pedestal)

43.0 k  Net (TV only)

42

43

• 

The sound is from built-in cooling fan 

(not a sign of faulty operation).

• 

Follow the message’s instructions.

• 

If the problem persists, contact the authorized Service Centre.

• 

Is “Colour” or “Contrast” in the Picture Menu set to the minimum? 

(p. 22)

• 

Check Colour system. (p. 25)

(no sound or low volume)

• 

Reset channels. (p. 24)

• 

Is “Sound mute” active? (p. 9)

• 

Is the volume set to the minimum?

• 

Sound signal reception may be deteriorated.

• 

Set “MPX” (p. 22) in the Sound Menu to “Mono”.

• 

Check Sound system. (p. 25)

• 

Set the sound setting of the connected equipment to 

“2ch L.PCM”.

• 

Check the “HDMI1 Input” setting in the Sound Menu. (p. 22)

• 

If digital sound connection has a problem, select analogue 

sound connection. (p. 33)

• 

Is the HDMI cable connected properly? (p. 36)

• 

Turn Off the TV and equipment, then turn them On again.

• 

Check an input signal from the equipment. (p. 40)

• 

Use an equipment compliant with EIA/CEA-861/861B.

• 

Turn off the TV with Mains power On / Off switch, then turn it on 

again.

• 

Off Timer function is activated.

• 

The TV enters “Standby mode” about 30 min. after broadcasting 

ends.

• 

Are the batteries installed correctly? (p. 6)

• 

Has the TV been switched On?

• 

Set “P-NR” in the Picture Menu (to remove noise). (p. 22)

• 

Check nearby electrical products

(car, motorcycle, fl uorescent lamp).

• 

Design and Specifi cations are subject to change without notice. Weight and Dimensions shown are approximate.

• 

This equipment complies with the EMC standards listed below. 

EN55013, EN61000-3-2, EN61000-3-3, EN55020, EN55022, EN55024.

• 

Confi rm the connection.

• 

Turn the connected equipment on and then switch the TV on. 

(p. 34)