Panasonic th85pb1u Benutzerhandbuch

Adjust the horizontal position.

Adjust the vertical position.

Adjust the horizontal size.

Adjust the vertical size.

(During Component/PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, 
adjust so that any such noise is minimized.

(During Component/PC input signal)
Eliminate the  ickering and distortion.

Turn image over scan ON/OFF.
Con gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)

            ON                                   OFF
Notes:
•  When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.
•  When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 54)

Notes:
•  If the dot clock frequency of an analog signal is 162 MHz or higher, “DOT CLOCK” and “CLOCK PHASE” 

cannot be automatically corrected.

•  When digital signal input, DOT CLOCK and CLOCK PHASE cannot be made.
•  AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright image 

with borders and other objects are clearly shown, and then try auto setup again.

• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out  ne tuning for the 

position/size as required.

• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz, 

1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page 
50) may results in correct AUTO SETUP.

•  AUTO SETUP does not work well when a signal such as additional information is superimposed out of 

valid image period or intervals between synchronizing and image signals are short, or for image signal with 
tri-level synchronizing signal added.

• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION ( ) then adjust 

POS./SIZE manually.