Panasonic th-65phd7e Benutzerhandbuch
8
SERIAL
PC IN
AUDIO
1
2
1
3
2
1
2
1
2
Connections
SPEAKER
Terminal (R)
Terminal (R)
SPEAKER
Terminal (L)
Terminal (L)
– Cable fixing bands Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Pass the attached cable
fixing band through the
clip as shown in the
figure.
fixing band through the
clip as shown in the
figure.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
From EXTERNAL monitor terminal
on Computer (see page 9)
on Computer (see page 9)
Optional Terminal Board insert Slots (covered)
To tighten:
To loosen:
Pull
Pull
Keep the knob
pressed.
pressed.
Note: The power plug in the illustration may not be the type fitted to your set.
SLOT1
SLOT2
SLOT3
– AC cord fixing
From SERIAL terminal on
Computer (see page 10)
Computer (see page 10)
Close
Open
Push until the hook clicks.
2. Pull off.
1. Keep the knob pressed.
1 Connect the AC cord plug to the Plasma Display.
2 Fix the left side clamper.
3 Fix the right side clamper.
2 Fix the left side clamper.
3 Fix the right side clamper.