Panasonic tx-26lxd60a Benutzerhandbuch
F
AQs, etc.
45
Problem
Actions
•
Frequently Asked
Questions
Screen
HDMI
Sound
DVB
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
some cases, despite good reception of analogue programmes.
Other
Chaotic image, noisy
•
Set "P-NR" in the Picture menu (to remove noise). (p. 21)
•
Check nearby electrical products (car, motorcycle, fl uorescent lamp).
No image can be displayed
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 21)
minimum? (p. 21)
Blurry or distorted image
(no sound or low volume)
•
Reset channels. (p. 28 and p. 30)
No sound is produced
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
Sound level is low
or sound is distorted
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set "NICAM" (p. 20) in the Sound menu to "Off".
(Analogue only)
(Analogue only)
Interference or
frozen / disappearing
image in DVB
frozen / disappearing
image in DVB
•
Check "Signal Condition". (p. 28)
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial.
If problem persists, consult your local Panasonic dealer.
If "Signal Quality" or "Signal Strength" are displayed in
red, check aerial.
If problem persists, consult your local Panasonic dealer.
•
Use the remote control to turn Off the TV unit, then turn
it On again.
it On again.
Sound is unusual
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 21)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 21)
analogue sound connection. (p. 21)
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
equipment are unusual
when the equipment is
connected via HDMI
•
Is the HDMI cable connected properly? (p. 40)
•
Turn Off the TV unit and equipment, then turn them On
again.
again.
•
Check an input signal from the equipment. (p. 43)
•
Use an equipment compliant with EIA/CEA-861/861B.
TV unit goes into
"Standby mode"
"Standby mode"
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
after broadcasting ends.
The remote control
does not work
does not work
•
Are the batteries installed correctly? (p. 6)
•
Has the TV unit been switched On?
"Control with HDMI"
function does not work
function does not work
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again. (p. 38)
•
Install an aerial individually for the TV unit and VCR
(or use a splitter).
(or use a splitter).
TV
VCR
(Individual aerial)
(Individual aerial)
Aerial
Input
terminal
Input
terminal
Splitter
Aerial Output
Aerial Input
Aerial Output
Unable to receive signals
with a high-performance
aerial
with a high-performance
aerial