FIC a440 Servicehandbuch

Answer:

For DOS installation, you must have a pre-installed MS-DOS v6.0 or higher operating system on your

hard disk with the “MSCDEX.EXE” (Microsoft CD Extension) driver file.

Both CD-ROM and DVD-ROM drive are ATAPI IDE interface and uses the same driver.

1. Boot up the system of your computer and insert the Teac CD-ROM driver diskette into

the floppy drive.

2. Change the directory of the DOS prompt to Drive A and run the CD-ROM installation

program by typing the command A:\>INSTALL and pressing <Enter>.

3. The “CD/DVD-ROM Setup Program” message appears for asking if you want to

continue the next step by pressing <Enter> or exit it by pressing <Esc>. Press

<Enter> to continue with the installation.

4. A connection diagram appears with a message shown “Confirm the connection

environment of the computer, are you sure ? ” Press <Y> to confirm.

The installation program will ask you to specify the directory where you want to place

CD/DVD-ROM driver. Press <Enter> to install into the default directory.

Press <Enter> to continue with the next step.

The Installation program will automatically copy the CD-ROM driver to your hard disk

and modify the AUTOEXEC.BAT and CONFIG.SYS files in activating the CD-ROM

drive every time you boot the system up.

Remove the diskette and restart the computer after installation is complete. Your

computer will then detect the CD-ROM drive and will display the designated drive

letter. The CD-ROM drive should be assigned to Drive D. If you have two disk

partition, the CD-ROM drive will be assigned to Drive E.

1.5 Question:

How to install the Audio Driver for Windows

98?

Answer:

1. Boot Windows from your hard disk and insert the disc containing the Audio driver.

2. Click

the

Start button, then click Run. In the Run dialog box, click the Browse button and navigate

into the directory where the new Audio driver is. Then, run “setup.exe”.

3. The Welcome message box appears. Click Next to continue with the next step.