FIC mb02 Servicehandbuch
Software Functional Overview
3-6
FIC MB02 Service Manual
1
1
0
1
1
1
1
0
1
1
1
1
3.3.4 Enhanced IDE
The system BIOS must be ready to support 4 IDE devises on two controllers. The BIOS
support Ultra DMA33/66/100 and also supports automatic configuration of drives using
both the LBA and CHS large drive remapping method. In addition to supporting
standard drives through an auto-configuration process that does NOT require user
involvement or confirmation. The system should automatically do this at POST time in a
way that is transparent to the user. If a drive is connected to the bus, the drive should be
automatically recognized, configured and available for use under MS-DOS 6.2x.
support Ultra DMA33/66/100 and also supports automatic configuration of drives using
both the LBA and CHS large drive remapping method. In addition to supporting
standard drives through an auto-configuration process that does NOT require user
involvement or confirmation. The system should automatically do this at POST time in a
way that is transparent to the user. If a drive is connected to the bus, the drive should be
automatically recognized, configured and available for use under MS-DOS 6.2x.
3.3.5 Audio
The audio subsystem will support the requirements identified by the AC’97 specification.
Both software and hardware will control the volume level for the internal audio subsystem. In
addition to the volume control, the user will be able to mute the sound to completely cut off
the volume using both software and hardware.
Both software and hardware will control the volume level for the internal audio subsystem. In
addition to the volume control, the user will be able to mute the sound to completely cut off
the volume using both software and hardware.
3.3.7 PCMCIA
The PCMCIA controller chip of the notebook provides the following features:
•
Individually accessed, dual-buffer implementation
•
Support for 2 separate CardBus slots (one type III or two type II stacked)
•
Support for 3.3v, 5v and 12v (flash programming) cards
3.3.8 LED Indicator
The table below lists down the functions of the Status LED indicator:
Indicator
Function Description
IDE accessing LEDŒ
This LED will turn on while accessing the IDE Device.
Battery Charging LED
Turn on (Blue) – Battery is under charging mode
Turn off – Battery full charged or no battery
Turn off – Battery full charged or no battery
CapsLock LEDŒ
This LED will turn on when the function of CapsLock is active.
ScrollLock LEDŒ
This LED will turn on when the function of ScrollLock is active.
NumLock LEDŒ
This LED will turn on when the function of NumLock is active.
Power Status LED
Blue – System is powered on.
Blue Blinking- System is entered suspend mode.
Trun off – Battery Low.
Blue Blinking- System is entered suspend mode.
Trun off – Battery Low.
Mail LEDŒ
This LED will turn on while Mail was arrived.
i
Π- These LEDs will be turned off during Suspend mode.
PDF created with FinePrint pdfFactory trial version