Gateway MAN FX510 Benutzerhandbuch
CHAPTER 6: Troubleshooting
112
4
Insert a blank, recordable disc into a recordable disc
drive, then click Next. If an AutoPlay dialog box opens,
click the x in the upper-right corner to close it.
drive, then click Next. If an AutoPlay dialog box opens,
click the x in the upper-right corner to close it.
A dialog box opens that tells you the number of blank
discs you will need to create a full set of recovery discs.
discs you will need to create a full set of recovery discs.
5
If you have enough blank discs of the specified type,
click I have enough discs, then click Next. If you do
not have enough discs, choose a different disc type, or
click Cancel.
click I have enough discs, then click Next. If you do
not have enough discs, choose a different disc type, or
click Cancel.
The disc recording begins. Label the discs as they are
completed.
completed.
6
If multiple discs are required, insert the additional blank
disks when prompted.
disks when prompted.
7
When the process is finished, the Congratulations!
window opens.
window opens.
8
Click Finish.
9
Remove your final disc, then label all of the discs and
store them in a safe place.
store them in a safe place.
Important
Use a permanent marker to label each disc “Software and Driver
Recovery,” along with a short description of which computer the discs
are for. If you are recording multiple discs, as you remove each disc
from the drive, use the marker to label each disc 1 of x, 2 of x, 3 of
x, and so on.
are for. If you are recording multiple discs, as you remove each disc
from the drive, use the marker to label each disc 1 of x, 2 of x, 3 of
x, and so on.
Tip
After a recovery disc is created, your computer names the disc
Recovery13 for disc 1 of a 3-disc set, Recovery23 for disc 2, and
so on.
so on.
8512066.book Page 112 Tuesday, January 16, 2007 11:02 AM