JVC SP-THS11BF Benutzerhandbuch

Do not connect the power cord until all other connections have been made.

• Place the satellite speakers on a flat and level surface.
• The front and center speakers are magnetically shielded to avoid color 

distortions on TVs. However, if not installed properly, they may 
cause color distortions. So, pay attention to the following when 
installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s main 

power switch or unplug it before installing the speakers. Then wait 
at least 30 minutes before turning on the TV’s main power switch 
again.

Some TVs may still be affected even though you have followed the 
above. If this happens, move the speakers away from the TV.

• The surround speakers and the subwoofer are not magnetically 

shielded.
If it is located nearby the TV or monitor, it will probably cause 
color distortion on the screen. To avoid this, do not place the 
speaker nearby the TV or monitor.

• Be sure to place the subwoofer to the TV’s right side. If you place the 

subwoofer to the TV’s left side, keep sufficient distance between 
them to prevent the TV screen from appearing mottled.

• Distortion of picture may occur when connecting the TV via a 

VCR, or to a TV with a built-in VCR.

• You need to set “MONITOR TYPE” in the PICTURE menu 

correctly according to the aspect ratio of your TV. (See page 29.)

7 To connect a TV equipped with the component video 

• If your TV supports progressive video input, you can enjoy a high 

quality picture by setting the progressive scan mode to active. (See 
page 12.)

• If the component video input jacks of your TV are of the BNC type, 

use a plug adapter (not supplied) to convert the pin plugs to BNC 
plugs.

• The video signals can be output only when you select “DVD” as the 

source to play. (See page 11.)

7 To connect a TV equipped with the S-VIDEO and/or 

• Select the appropriate scan mode according to your TV. (See page 

12.)

You can enjoy the sound of an analog component.

• If you connect a sound-enhancing device such as a graphic equalizer 

between the source components and this system, the sound output 
through this system may be distorted.

• When playing a video component such as a VCR;

•

To listen to the sound, select “AUX” as the source to play. (See 
page 11.)

•

To see the picture, connect the video output jack of the component 
to the video input jack of the TV directly, and select the correct 
input mode on the TV.

Make sure that all other connections have been completed.

• Disconnect the power cord before cleaning or moving the system.
• Do not pull on the power cord to unplug the cord. When unplugging 

the cord, always grasp and pull the plug so as not to damage the cord.

• Preset settings, such as preset stations and surround mode adjustment, 

may be erased in a few days in the following cases;

•

If you unplug the power cord of the center unit.

•

If a power failure occurs.

Front right 
speaker

Center speaker

Subwoofer

Surround left 
speaker

Surround right 
speaker

Front left

speaker

Center unit

To component

video input

TV

Component video cord (not supplied)

Center unit

TV

S-VIDEO cord 

(not supplied)

Composite video cord 
(supplied)

RCA pin plug cord 
(not supplied)

Center unit

VCR

TV

Cassette recorder

To audio output

Center unit

Power cord

Plug into AC outlets.

TH-S11B[J].book  Page 8  Tuesday, May 8, 2007  4:15 PM