kymco mo kxr 50 Servicehandbuch

Install the damper rubbers on the drive plate

pins.

Install the clutch weights/shoes and clutch

springs.
Set the circlips in the groove.

Clean the driven pulley faces and remove any

grease from them.

Install the oil seal onto the moveable driven

face.

Apply grease onto the Oil seal and install

them onto the moveable driven face.

Install the movable driven face onto the

driven face.

Apply  grease  to  the  guide rollers  and  guide

roller pins and then install them into the holes

of the driven face.

Install the seal collar.

Remove any excessive grease.

Set the driven pulley assembly, collar (OFF

ROAD), driven face spring and clutch

assembly onto the clutch spring compressor.

Compress the clutch spring compressor and

install the drive plate nut.

Set the clutch spring compressor in a vise and
tighten the drive plate nut to the specified
torque.
Torque: 5.0_ 6.0kgf-m

Clutch Spring Compressor   E027

Be sure to clean the driven face off any

grease.

Align the flat surface of the driven face

with the flat on the clutch drive plate.

Be sure to use a clutch spring

compressor to avoid spring damage.

Special

Clutch Spring Compressor

Lock  Nut  Wrench,  39mm

Driven  Pulley

Collar (OFF ROAD)

Spring

Clutch

Nut