BMW serie 7 1999 Benutzerhandbuch

109

Repairs

Index

Overview

Controls

Car care

Technology

Data

Integrated Universal Remote Control

Programming

1 Channel keys

2 Indicator lamp

3 Receiver for programming

Read and comply with the safety
precautions on page

108

1 Ignition key position 2
2 For initial use: Press and hold both

outside keys 1 until the indicator lamp
2 flashes, and then release them. The
three channel keys are cleared

380us202

3 Hold the original hand-held transmit-

ter toward the receiver 3 a maximum
of 2 inches (5 cm) away

4 Press the transmission key of the

original hand-held transmitters
(arrow 2) and the desired channel key
of the Integrated Universal Remote
Control (arrow 1) simultaneously. Re-
lease both keys as soon as the indi-
cator lamp flashes rapidly

5 To program other original hand-held

transmitters, repeat steps 3 and 4.

The corresponding channel key is now
programmed with the signal of the orig-
inal hand-held transmitter.

380de668

Programming a hand-held
transmitter with conversion code

Read and comply with the safety
precautions on page

108

When programming the Integrated Uni-
versal Remote Control, consult the in-
structions for the specific device. For
using the Integrated Universal Remote
Control with a conversion-code system,
note the following supplemental pro-
gramming instructions:

A second person facilitates pro-
gramming of the Integrated Uni-

versal Remote Control.

1 Program the Integrated Universal Re-

mote Control as described previously
under "Programming"

2 Press and hold the programming key

on the receiver of the device for ap-
proximately two seconds until the
programming light on the device
comes on

3 Press the desired channel key of the

Integrated Universal Remote Control
three times.

If you have additional questions,
please consult your BMW center.