Siemens MC35 Benutzerhandbuch
AT Command Set
MC35_ATC_01_V05.00
Page 222 of 256
15.07.2002
8.37 AT^SRTC Select, query, test ring tone parameters
Test command
AT^SRTC=?
Response
^SRTC: (list of supported
<type>s), (list of supported <vol>s) OK
Read command
AT^SRTC?
Response
^SRTC: <type>, <vol>, <stat> OK
Parameters
<type>
Type of ringing tone. 7 different tones and melodies can be
selected:
1 – 7 (factory setting is <type>=3)
selected:
1 – 7 (factory setting is <type>=3)
<vol>
Volume of ringing tone. Varies from low to high.
0 Mute (factory setting)
1 Very low (initial setting after firmware update)
2
Identical
with
1
3
Low
4
Identical
with
3
5
Middle
6
Identical
with
5
7
High
<stat> Status of test ringing. Indicates whether or not a melody is
currently being played back for testing.
0 Playback is off.
1 Playback is on.
The Read command can be used while test playback is off or on. In
the latter case, see Execute command for details.
Write command
AT^SRTC=[<type>][,<vol>]
Response
^SRTC: <type>, <vol>OK
Parameters
See Read command
The Write command selects the type and volume of ringing tones. It
can be used while test playback is off or on. In the latter case, see
Execute command for details.
The selected type and volume apply to all audio modes. Also they are
saved in the non-volatile Flash memory and, thus, are retained after
Power Down.
Before first using ringing tones:
We have chosen to let you decide your own preferences when you
start using ringing tones. Therefore, factory setting is AT^SRTC=3,0,0
(ringing tones are muted). To activate ringing tones for the very first
time, first enter the Write command and simply change the volume.
After a firmware update the volume will be reset to <vol>=1. The
<type> selected before the firmware update will be preserved.
The Write command selects the type and volume of ringing tones. It
can be used while test playback is off or on. In the latter case, see
Execute command for details.
The selected type and volume apply to all audio modes. Also they are
saved in the non-volatile Flash memory and, thus, are retained after
Power Down.
Before first using ringing tones:
We have chosen to let you decide your own preferences when you
start using ringing tones. Therefore, factory setting is AT^SRTC=3,0,0
(ringing tones are muted). To activate ringing tones for the very first
time, first enter the Write command and simply change the volume.
After a firmware update the volume will be reset to <vol>=1. The
<type> selected before the firmware update will be preserved.