Eurotech Appliances apollo 1u ice fm12961 Benutzerhandbuch

Seite von 37
 
APOLLO 1U ICE 
Internal configuration   
Remove any cables attached to installed PCI expansion cards before attempting 
removal of the PCI module.   
To remove the PCI Module, follow these steps: 
1
  Unplug the flexible riser connection to the APOLLO SBC. 
 
Take care to pull on the plug-in connector rather than the flexible cable. 
2
  Disconnect the tamper detect cable from front panel breakout board assembly. 
The PCI module is retained in the enclosure by formed lugs on the base, and one 
retaining screw. 
3
  Unscrew the retainer and slide the PCI Module back to clear the lugs on the base, 
and lift out. 
 
Be careful of the tamper detect switch and cable when the PCI module is 
removed. 
To fit a PCI card: 
1
  Remove the blanking plate. 
2
  Plug the card into the riser. 
3
  Adjust and fix the support bracket to suit. 
4
  Tighten the retaining screw. 
To install the PCI Module, reverse the procedure outlined above. 
© 2007 Eurotech Ltd    Issue C 
23