Epson small-in-one nx430 Benutzerhandbuch

 

 Slide the edge guide to the left.

 

 Load paper against the right edge guide and behind the 
tab line on the left edge guide, with the printable side 
faceup.

 

 

 Don’t load the paper sideways; always load it short 

edge first.

 

 Slide the edge guide over, against the left edge of 
the paper.

 

 Flip the feeder guard back. 

 Do not open ink cartridge packages until you are ready to 

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials, including from inside the printer.

 

 Raise the paper support, then connect the power cord to 
the back of the printer and to an electrical outlet.

 

 Do not connect to your computer yet.

 

Raise the control panel, then press the

power button.

 

 

If you want to lower the control panel, squeeze the release 

bar underneath.

 

 

 Do not lower the control panel without first squeezing the 

release bar underneath or you may damage the product.

 To select English as your language, press OK.

If you want to change the language, press 

 or 

 to select it, then 

press OK.

 You can change the language later using the product’s control 

panel. For more information, see the online User’s Guide.

 Don’t load paper yet. 

 

 Lift up the scanner unit, and wait until the ink cartridge 
holder stops moving.

 

 Shake the ink cartridges gently 4 or 5 times, then 
unpack them.

 

Remove only the yellow tape from each cartridge.

 

 

 Don’t remove any other seals or the cartridges may leak.

 

 Insert the cartridges in the holder for each color, and press 
each cartridge down until it clicks.

 

Lower the scanner unit.

Press OK to prime the ink delivery system. Priming takes 
about 4 minutes.

 

 

 Your printer ships with full cartridges and part of the ink from 

the first cartridges is used for priming the printer.

 Don’t turn off the printer while it is priming or you’ll 

waste ink.

 

 When you see this menu on your product’s LCD screen, do 
not press any buttons yet. Continue with the instructions in 
the following sections. 

 

 Flip the feeder guard forward. 

   Raise the paper support, if necessary. Then pull up the 

extension and tilt it back slightly.

 

Pull out the output tray, then raise the paper stopper.

*412184000*

Epson Stylus

®

 NX430

Small-in-One

™

Start Here