HP Compaq KB-9965 311059-041 Benutzerhandbuch

3.  Be sure that the power supplies are working properly by checking the power supply 

LEDs. 

 

 For information on LEDs and switches specific to the server, refer to Chapter 4, 

“Connectors, LEDs, and Switches.” For more information about power, refer to the HP Servers 
Troubleshooting Guide. 

4.  If the system does not complete POST or start loading an operating system, refer to the 

HP Servers Troubleshooting Guide. 

5.  If the server is rebooting repeatedly, verify that the system is not rebooting due to a 

problem that initiates an ASR-2 reboot. 

Some operating systems reboot the server when an error occurs. This is the default in the 
Windows® 2000 operating system. 

6.  Restart the server. 

 

  If the server does not restart, proceed to “Diagnostic Steps.” 

7.  Check the server for the following normal power-up sequence to be sure that the system 

meets the minimal hardware requirements and is powered up during normal operations: 

a.  The power button LED turns from standby (amber) to on (green). 

b.  The fans start up. 

8.  Check the monitor for the following messages that verify the system meets the minimal 

hardware requirements and is powered up during normal operations: 

a.  HP ProLiant logo 

b. BIOS 

information 

c. Copyright 

information 

d. Processor 

initialization 

e. Multi-initiator 

configuration 

 

  Select the multi-initiator configuration utility (CTRL-A) only to support HP storage 

and clustering options. Refer to the HP ProLiant ML570 Generation 2 Server Setup and Installation 

Guide. 

f. PXE 

initialization 

g. Option 

ROMs 

h. SCSI 

devices 

9.  The operating system loads to complete the boot process. 

If the server completes POST and attempts to load the operating system, go to the “Problems 
After Initial Boot” section in this chapter.