Trimble Outdoors r7-r8 Benutzerhandbuch

3       Setting up the Receiver

2 6      Trimble R7/R8 GPS Receiver User Guide

To mount the TSC1™/TSCe™ controller on the pole:

1.

Mount the controller bracket on the pole:

a.

Place the bracket against the pole at a comfortable height.

b.

Rotate the clamping screw on the bracket pole until tight. 

c.

Place the controller into the cradle assembly and tighten 
the clamping mechanism.

d.

Any cables running down the pole should be run through 
the machined groove on the inside of the controller 
bracket.

e.

Position the controller in the preferred position for 
operation by pressing the spring-loaded release button on 
the cradle, pulling the assembly outward, and rotating the 
cradle assembly to the desired angle. Reseat the cradle in 
the proper position by lining up the alignment pins and 
pushing inward until the release button locks.

2.

Connect one end of the 2 ft 0-shell to 0-shell Lemo cable to the 
TSC1/TSCe controller.

3.

Connect the other end of the Lemo cable to Port 1 on the 
receiver.

4.

Place the hand grip below the controller bracket (or above it, 
depending on the position of the bracket), with the cables 
running through the grip.

5.

Secure any loose cables, using the velcro cable ties.