AstroStart 2305a Benutzerhandbuch

A maximum of four remote controls can be assigned to your vehicle. See your dealer for additional remote controls. 
NOTE: The range of your remote control can be affected by weak batteries, interference from nearby metal structures, 
hydro poles, or crowded parking lots. 

To send a command, press for two seconds on the appropriate button. 
Command may not be sent if the button is not pressed long enough.  
The remote control beeps when a button is pressed, then emits ten short beeps 
during the transmission. 
Your remote control can transmit on two different channels, allowing control of 
two separate vehicles. Only the “Panic” command is transmitted on both 
channels simultaneously. 
An audible confirmation (piezo) is emitted along with a visual confirmation (LED 
indicator) each time a command is sent. 
The remote control pictured may differ from that included in the kit. 
Your system may be programmed in such a way that it can distinguish between 
two groups of remote controls (maximum: two remotes per group). These groups 
let you activate predefined settings on certain vehicles (seat, mirror and other), 
for example, when unlocking (additional optional equipment required). 

  

To transmit a command  
on channel 1, press desired 
button for two seconds. 

  

To transmit a command on channel 2, press desired button, then as soon as a beep is 
heard, release the button for a moment then press it again and hold it down for two 
seconds. The remote beeps twice to confirm transmission on channel 2. 

 

As soon as a command is sent, the remote switches over to standby mode in order to receive and display confirmations 
sent by the command module installed in the vehicle.  
These signals are transmitted only once and could be neutralized by radio or electromagnetic interferences generated by 
electronic devices in the vicinity. 
If no confirmation is received in a given location, move away from electronic devices and activate the "Status" command 
(  then 

). The start module will inform you of the status of door locks, alarm, and running of the engine (See Table of 

commands on page 6). 

 

Note that the communication between the vehicle and the transmitter operates in only one direction at a time. This is why it 
is recommended to wait for the confirmation before sending another command. Otherwise, the vehicle and the transmitter 
could transmit at the same time wich would block the command as well as the returned confirmation. 
Out of range 
If the vehicle is out of range, the transmitter will emit a soft chirp after 3 seconds and all the buttons will flash except those 
that where pressed to send the commande to indicate that the command has not been received by neither the module nor 
the transmitter. 

Each time a command is transmitted, the system returns a confirmation acknowledging the command was received. 
The confirmation consists of the blinking of the LEDs used to transmit the command.