TiVo DVR Benutzerhandbuch
6 of 6
11. SECURING THE TWINBREEZE BRACKET TO THE BASE OF THE TIVO
Insert a metal washer onto each of the two remaining self-
tapping screws. Use one hand to push the bracket down.
Using your other hand, lift the left edge of the TiVo. Using
Figure 17 as a guide, locate the pre-drilled holes in the
bracket feet, which should be visible through the grates.
tapping screws. Use one hand to push the bracket down.
Using your other hand, lift the left edge of the TiVo. Using
Figure 17 as a guide, locate the pre-drilled holes in the
bracket feet, which should be visible through the grates.
Be sure that the bracket mounts are aligned properly –
counting from the gap between the sets of holes, you should
be screwing into the fourth hole towards the back, and the
third hole towards the front. If the bracket isn’t sitting there,
you may need to adjust its position a bit to get it there.
counting from the gap between the sets of holes, you should
be screwing into the fourth hole towards the back, and the
third hole towards the front. If the bracket isn’t sitting there,
you may need to adjust its position a bit to get it there.
Once you have the bracket aligned, insert the self-tapping
screws through correct hole in the bottom of the TiVo and
into the pre-drilled holes in the bracket.
screws through correct hole in the bottom of the TiVo and
into the pre-drilled holes in the bracket.
Gently tighten the screws in place. Do not overtighten.
Once you have secured the bracket using the two self-
tapping screws, your TiVo should look like Figure 18.
tapping screws, your TiVo should look like Figure 18.
Figure 17 (above) Bottom left side view
Figure 18 (above)
12. RE-ATTACHING THE TIVO LID
Place the TiVo lid back over the TiVo. Align the clips on each side
of the lid so that they clip down on the sides of your TiVo. Slide the
lid toward you while simultaneously pushing gently down on the
top of the lid. See Figure 19. Once the lid is in place, reattach the
five Torx screws. Plug in your TiVo and enjoy!
of the lid so that they clip down on the sides of your TiVo. Slide the
lid toward you while simultaneously pushing gently down on the
top of the lid. See Figure 19. Once the lid is in place, reattach the
five Torx screws. Plug in your TiVo and enjoy!
You can verify your new capacity by looking in the System
Information screen of your TiVo. The System Information screen is
located in the “Messages and Setup” menu. Once in the System
Information screen, you will see “Variable up to XXX hours” (you
may have to scroll down the page using the “channel down”
button). This message gives you the maximum capacity of your
unit, after the upgrade..
Information screen of your TiVo. The System Information screen is
located in the “Messages and Setup” menu. Once in the System
Information screen, you will see “Variable up to XXX hours” (you
may have to scroll down the page using the “channel down”
button). This message gives you the maximum capacity of your
unit, after the upgrade..
Figure 19
We thank you very much for your purchase and hope that you enjoy your newly-enhanced TiVo. Please
email us
with
any comments, suggestions or complaints. If you found the upgrade easy to install (or even if you found it more
difficult than you expected), we’d love to know. If you found our service to be excellent (or awful), we want to know
that too. We’re always looking to improve our products and services…the more we hear from you, the better. Thanks
very much!
difficult than you expected), we’d love to know. If you found our service to be excellent (or awful), we want to know
that too. We’re always looking to improve our products and services…the more we hear from you, the better. Thanks
very much!