Troy-Bilt TB210 Benutzerhandbuch

The transmission is pre-lubricated and sealed at the factory and 

2. 

does not require lubrication.
Follow the accompanying engine manual for lubrication 

3. 

schedule and instruction for engine lubrication.

Clean underside of the mower deck after each use to prevent 
build-up of grass clippings or other debris. Follow steps below 
for this job.

Disconnect spark plug wire. Drain gasoline from lawn 

1. 

mower or place a piece of plastic under the gas cap.
Tip mower so that it rests on the housing. Keep the side 

2. 

with the air cleaner facing up. Hold mower firmly.

Never tip the mower more than 90º in 

any direction and do not leave the mower tipped for 
any length of time. Oil can drain into the upper part 
of the engine causing a starting problem.

3. 

Scrape and clean the underside of the deck with a suitable 
tool. 

4. 

Put the mower back on its wheels on the ground. If you had 
put plastic under the gas cap earlier, make sure to remove it 
now.

Always observe safety rules when performing any 

•

maintenance.
The warranty on this lawn mower does not cover items that 

•

have been subjected to operator abuse or negligence. To 
receive full value from warranty, operator must maintain 
the lawn mower as instructed here.
Changing of engine-governed speed will void engine 

•

warranty.
All adjustments should be checked at least once each 

•

season.
Periodically check all fasteners and make sure these are 

•

tight.

Always stop engine, disconnect spark 

plug, and ground against engine before performing 
any type of maintenance on your machine.

Lubricate pivot points on the blade and drive controls at least 

1. 

once a season with light oil. These controls must operate 
freely in both directions. See Fig. 6-1.