Tally Genicom 6600 Benutzerhandbuch
38
Chapter
2
Block Character Fonts
10 CPI
The 10 CPI block character set is 0.1 inches high and is selected by using the
following Graphics Pass Command.
following Graphics Pass Command.
Command ^{M,U,V,E}0101jjd<data>^-
Arguments
^{M,U,V,E}
One of four Graphics Pass orientations (^M for
horizontal, ^V for clockwise rotation, ^E for
counterclockwise rotation, or ^U for upside down
and reverse order of characters).
horizontal, ^V for clockwise rotation, ^E for
counterclockwise rotation, or ^U for upside down
and reverse order of characters).
0101
A height/width value of 0101 specifies 10 CPI
characters.
characters.
jjd
Justification values in increments of 0.1 inches
(0.25 cm) and dot rows as discussed in the
Graphics Pass Command description below. This
field may be omitted entirely if the justification value
is zero.
(0.25 cm) and dot rows as discussed in the
Graphics Pass Command description below. This
field may be omitted entirely if the justification value
is zero.
<data>
The characters to be printed.
Example 1: The Graphics Pass ^M0101000HORIZONTAL 10 CPI^- prints:
Example 2: ^M0101000HORIZONTAL 10 CPI
^M0202000HORIZONTAL 5 CPI^- prints: