HP Compaq KB-9965 311059-051 Benutzerhandbuch

7.  Lift the PPM straight up from its slot. 

 

Reverse steps 1 through 7 to replace a PPM. 

 

  When installing a PPM, be sure the key slot in the PPM is aligned with the key in the 

slot. 

To remove a processor: 

1.  Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for 

Non-Hot-Plug Procedures” in this chapter. 

2.  Remove the front bezel door (tower model only), and lay the server on its side with the 

access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model 
Only)” in this chapter. 

3.  Remove the access panel. Refer to “Removing the Access Panel” in this chapter. 

4.  Remove the rear and front processor air baffles. Refer to “Processor Air Baffles” in this 

chapter.