Epson workforce 610 series Benutzerhandbuch

                               

If anything is missing, contact Epson as described on the back under 
“Any questions?”.

 

The model name of your product may vary slightly from the one shown above. 

The included CD and documentation apply to all products in the series. 

 

Do not open ink cartridge packages until you are ready to install the ink. 

Cartridges are vacuum packed to maintain reliability. 

Canada only: For French speakers, remove stickers from the backing sheet and place 
over corresponding text on the control panel. 

Remove all protective materials. 

 

Start Here

Select your language.

 Press

or

to select the 

desired option.

 Press 

OK when done.

Select your country/region, then press OK.

 

For the Daylight Saving Time setting, select Summer if your region uses 
Daylight Saving Time and it’s currently in effect. (DST is effective from 
spring through summer.) Otherwise, select Winter to turn off the setting. 
Press OK.

Press 

 or 

 to select the date format, 

then press  . 

Don’t press OK yet.

Use the numeric keypad to set the date. 

Don’t press OK yet.

Press 

 or 

 to select the time format, 

then press  . 

Don’t press OK yet.

 

Use the numeric keypad to set the time.

If you selected 12h as the time format, press 

 or 

 to 

select AM or PM.

Press OK when done.

 

You can change the date and time settings by pressing the Home button, 

selecting Setup, selecting Printer Setup, then selecting Date/Time.

Open the paper support and pull up the extensions.

Extend the output tray and raise the stopper.

 If you are using legal-size paper, do not raise the stopper.

Hold the feeder guard forward, then squeeze the edge guide and slide it 
to the left.

Load paper against the right edge guide and behind the tab, with the 
printable side face up.

Don’t load the paper sideways; always load it 

short edge first.

Slide the edge guide over.

 

Don’t load paper before installing the ink cartridges.

Lift up the scanner.

 Open the cartridge cover.

Shake the ink cartridges 
gently 4 or 5 times, then 
unpack them.

Remove only the yellow tape from each cartridge.

 

Don’t remove any other seals or the cartridges may leak.

Insert the cartridges in the 
holder for each color.

Press each cartridge down until it clicks.

Close the ink cartridge cover and press it 
down until it clicks.

Lower the scanner.

Press the OK button to charge the ink. Charging takes about 3 minutes.

 Your product ships with full cartridges and part of the ink from the fi rst 

cartridges is used for priming the product.

 

Don’t turn off the product while the ink system is charging or you’ll 

waste ink.

Connect the power cable.

 

 Do not connect to your computer yet.

Lift the control panel to raise it, then press the

On button.

On

 

To lower the control panel, squeeze the release lever underneath and push the 

control panel down. For more information on using and adjusting the control panel, 
see your Quick Guide.

Series