Star Micronics TCP100 Series Benutzerhandbuch

6

0

6

1

5

4

8

3

7

2

0

A

8

7

9

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

○

Housed unit TCP100/2000 series

[TCP100]

[TCP2000 back]

1 Switch Cover

This cover protects the power switch of the system.
Push to open and close.

2 Power Switch

This switch turns the power of the system ON/OFF.

3 POWER LED

This LED indicates that the power of the system is on.

4 READY LED

This LED indicates that the card processing is ready.

5 OK LED

This LED indicates that the card has been processed
without error.

6 ERROR LED

This LED indicates that the card has not been read due
to an error e.g. jamming of the card in the reader/writer.

7RS232C Serial Connector This connector interfaces the connection between host

computers and the reader/writer.

8 AC Power Inlet

Connect this inlet to the power source with the attached

AC power cable.

9 Cleaning Button

Push this button under the power ON condition, then
insert the cleaning card which is soaked with the clean-
ing liquid.

0 Modular Connector This interfaces the connection between MCD2000 (Star

original numerical key pad).

A Interface convert switch This switch changes the available interface : RS232C

(right side) or modular connector (left side).

   

 

IMPORTANT!

A three terminal earth grounded power supply cable is attached to TCP100/
2000 housed unit.  For safety, do not remove the ground pin.

4