Top Innovations sf-777 Benutzerhandbuch

Operating the Appliance

STEP ONE

SET the Temperature Control Dial to the OFF position.

STEP TWO

PLUG the unit into a proper polarized outlet.

STEP THREE

SET the Temperature Control Dial to the desired position. Leave the iron on

the hear resistant pads of the reservoir tank while the soleplate of the iron

heats for about two minutes.

STEP FOUR

When the iron has heated to the proper setting the red indicator light will go

OFF. You may begin ironing.

STEP FIVE

For STEAM – DEPRESS the Steam Button and approximately five seconds

later water will be pumped from the Reservoir into the iron, heated and burst

out from the soleplate. The blast of steam comes from the front portion of the

soleplate so position it accordingly.

When you are finished ironing, place the iron on the heat resistant pads

of the reservoir tank until it cools completely.

IMPORTANT NOTE :

The red indicator light will go ON periodically to show that the

temperature has dropped below the level desired. Simply wait for the

light to go out to continue, EXCEPT, when changing the iron from a

higher setting to a lower one. You must WAIT for the light to go ON and

then OFF again before continuing to ensure the soleplate of the iron is

not too hot.

FOR MORE INFORMATION on the types of fabrics ironed in various

settings please refer to the Fabric Chart on page 11.

Because The SteamJet Station Iron produces a burst of steam greater than

normal irons, it can be used vertically as well as horizontally.