Simplicity Manufacturing i75246e Benutzerhandbuch

TP 300-5196-00-IS-SN

6/2006

1. Drain the fuel tank and run engine out of gas.

2. Disconnect spark plug wire and fasten it away from

the spark plug.

3. Remove belt cover.

4. Loosen auger belt guide and slide belt off engine pul-

ley and away from idler pulley. (See Figure 28).

5. Depress and secure both the auger and traction con-

trol levers to provide clearance for belt removal.

6. Tilt the snowthrower forward and rest it on the auger

housing.

7. Remove lower cover.

8. Loosen hex screws securing the belt stop (Figure 29),

and pivot the belt stop away from the pulley to permit
removal of belt.

9. Pull the belt out of the unit, and install the new belt on

the auger drive pulley.

10. Position belt stop to provide 1/8" clearance between

stop and belt when engaged, and tighten securely.

11. Replace lower cover.

12. Return unit to normal upright operating position.

13. Remove both control levers.

14. Install auger belt over engine pulley.

15. Adjust auger belt guide as described under ADJUST-

ING AUGER BELT GUIDE.

16. Install belt cover.

17. Connect spark plug wire and fill fuel tank.

18. Start Unit and check auger for proper operation. See

DRIVE BELT ADJUSTMENT PROCEDURES if addi-
tional adjustment is necessary.