AstroStart 2101 Benutzerhandbuch
4
THE REMOTE CONTROL
Your remote control works off two small 3 volts lithium batteries ( CR2016).
See your dealer for replacement batteries or additional remote controls.
The range of your remote control can be affected by a weak battery, interference from
nearby metal structures, hydro poles, or crowded parking lots.
With its electronic CODE LEARNING feature, up to four remote controls can be
programmed for your vehicle.
See your dealer for replacement batteries or additional remote controls.
The range of your remote control can be affected by a weak battery, interference from
nearby metal structures, hydro poles, or crowded parking lots.
With its electronic CODE LEARNING feature, up to four remote controls can be
programmed for your vehicle.
USING YOUR REMOTE CONTROL
To ensure that commands are transmitted properly, press desired
button for 2 seconds. A command will not be executed if you do not
press button long enough.
Indicator light will flash while transmitting the command.
Model 903: Your system can be configured (during installation) in
such a way that the remote control will only access the starting
function of your vehicle or it can access both the starting and door
locking functions of the vehicle.
The keypad shows pictograms to help you remember the commands;
use the keypad that corresponds to your system options.
You can replace the buttons (rubber keypad) of your remote control
by an alternate keypad (ask your dealer).
Remote(s) included in kit may differ from the ones illustrated.
button for 2 seconds. A command will not be executed if you do not
press button long enough.
Indicator light will flash while transmitting the command.
Model 903: Your system can be configured (during installation) in
such a way that the remote control will only access the starting
function of your vehicle or it can access both the starting and door
locking functions of the vehicle.
The keypad shows pictograms to help you remember the commands;
use the keypad that corresponds to your system options.
You can replace the buttons (rubber keypad) of your remote control
by an alternate keypad (ask your dealer).
Remote(s) included in kit may differ from the ones illustrated.
TABLE OF COMMANDS
B
UTTONS
C
OMMANDS
903
C
ONFIRMATION
S
ELECTED OPTION
⇒
801
2101
O
PTION
1 O
PTION
2
L
IGHTS
H
ORN
801
2101
S
TART
/ S
TOP
(T
OGGLE
)
1 / 1
-
S
TOP
1 -
S
TART
1 / 1
1
L
OW TEMPERATURE MODE
4 / 2 / 3
-
P
ANIC
(B
UTTON HELD IN
> 4
SEC
.)
OR
OR
30 / 60
SEC
.
T
RUNK
3 -
U
NLOCK
2 -
903
L
OCK
1 1
T
HIS CONFIRMATION IS SENT ONLY WHEN COMMAND IS REPEATED WHILE ENGINE IS ALREADY RUNNING
.
4 = A
CTIVATION
/ 2 = D
EACTIVATION
/ 3 = S
YSTEM NOT READY
P
ROGRAMMABLE DURING INSTALLATION
– 2
ND
LOCK
Note: Make sure that the remote control is covered with the appropriate keypad, i.e. pictograms that correspond with the
command options programmed to your system (See “ Using your remote control”).
command options programmed to your system (See “ Using your remote control”).
801 & 2101
903
Option 1
Option 2