Autostart as-2350vtw-fm Benutzerhandbuch

Seite von 16
 
P. 8 
User Guide
  
Ignition-controlled Door Locks 
This is an added security feature. If your Remote Car Starter was installed with the Ignition-
Controlled Door Locks option, the doors will automatically be locked as soon as the ignition key is 
turned to the 
IGNITION ON (RUN)
 position while the brakes are pressed. When the key is turned to the 
OFF
 position, the doors will automatically be unlocked. 
Ignition Re-lock 
On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the 
ignition key is in the 
IGNITION ON (RUN)
 position, should any door be unlocked and opened, all doors 
will be relocked next time the brake pedal is pressed. 
Secure Lock 
Before it can remote-start your vehicle, the Remote Car Starter must first disarm the factory 
security system. The Secure Lock feature may be required on certain vehicle models with factory 
security systems that automatically unlock the doors when the security system is disarmed. 
To keep your vehicle protected when the factory security system is disarmed for a remote start, 
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle 
ends, Secure Lock will rearm your factory security system. 
Remote Trunk Release 
If your system was installed with the remote trunk release option, you can open your trunk by 
pressing the 
TRUNK
 button for 3 seconds.
 
The OEM alarm will be disarmed until the 
LOCK
 button is 
pressed.  
The Starter Kill and the Anti-grind Feature 
With this added security feature, the system will prevent your vehicle from starting with the ignition 
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill 
option, one will not be able to start your vehicle with the key unless the system has been unlocked 
and disarmed first, or put into Valet Mode. 
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter 
motor damage that could occur after remote-starting the engine should the user, by force of 
habit, turn the ignition key to the 
CRANK
 position. 
Safe Start 
If this feature is enabled, the user must press the 
START/STOP
 button 2 times within 3 seconds to 
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing 
with the transmitter. 
1. Press and release the 
START/STOP
 button. 
The parking lights will turn on. 
2. Within 2 seconds of the parking lights turning on, press and release 
START/STOP
 again (before 
the parking lights turn off). 
 
If Swap Start Mode is selected, to remote-start your vehicle press 
SHIFT
 and then 
LOCK
. The 
AUX 2
 
output can be activated by pressing the 
START/STOP
 button. 
Installer-Programmable Valet Modes 
Valet Mode Using the Valet Switch (if installed) 
To put the system  i n t o   Valet Mode: 
• 
Turn the ignition key to the 
IGNITION ON (RUN)
 position. 
• 
Within 3 sec., press the valet button, the parking lights will flash three times and the  
 
L.E.D. will come on solid once the ignition key is removed. 
To take the system  o u t   o f   Valet Mode: 
• 
Turn the ignition key to the 
IGNITION ON (RUN)
 position.