TEAC quick 552e Benutzerhandbuch

Seite von 2
TEAC CD-552E CD-ROM Drive
Quick Installation Guide
page 2
(7)
Connect the PC to the wall outlet and switch it on.
Important:
If your PC will not start up correctly switch it
off immediately and check all of the connec-
tions and jumper settings.
Maintenance and Cleaning
Maintenance and repairs shall only be carried out by
qualified personal and specialized firms. Otherwise the
drive may be severely damaged.
The front panel of the drive may be cleaned with a soft
dry cloth. Heavier kinds of solings are removed with a
damp cloth and a little bit of a non-aggressive cleaning
fluid.
Caution:
Do not use cleaning CDs which will remove
dirt of the lense of the laser aided by a little
brush. Do not clean the inner parts of your
TEAC CD-ROM drive with compressed air.
Any of these methods may cause damage to
your TEAC CD-ROM drive.
Software Installation
Windows 95/98/ME/2000/XP does not require a soft-
ware installation. The drive is recognized automatically.
If you like to access the drive under DOS (not neces-
sary for the DOS box of Windows 95/98/ME/2000/XP)
you have to insert the CD-ROM driver into “Config.sys”
and MSCDEX.EXE into “AUTOEXEC.BAT”. Please
copy the CD-ROM driver from the drivers floppy to your
hard disk.
CONFIG.SYS:
DEVICE=C:\CDROMDRV.SYS  /D:MSCD001
AUTOEXEC.BAT:
C:\WINDOWS\COMMAND\MSCDEX.EXE  /D:MSCD001
Handling
Check the CD-ROM before inserting it into the drive. It
should not have finger prints or other dirt on it. Espe-
cially at high reading velocities dirt may increase the
number of reading errors.
Very important:
Shape CDs, a kind of CD which is not shaped
like the normal round CD, are not allowed to
be used in this drive. Otherwise rotational
forces may cause severe damage to the drive.
Reproducing Audio CDs
Audio CDs may be reproduced with special software
like the CD Player of Windows95/98/ME/2000/XP. Au-
dio CDs are recognized and played automatically. Oth-
erwise you may use the keys on the drive itself:
Play/skip key
Eject/stop key
Head-
phone jack
Busy LED
Volume control
In case of warranty: www.teac.de/support/german/index.htm
a)
Play/Skip
After inserting an audio CD you have to press this
key to start the reproduction. In some cases it can
be necessary to adjust the volume at your sound
card. Pressing the key again starts the next music
title. The remaining music of the title reproduced
before is skipped.
b)
Eject/Stop
Pressing this key once during the reproduction of
a music title stops playing the title. Pressing the
key again ejects the CD tray containing the audio
CD.
Very important:
Please do not try to reproduce data CDs un-
der any circumstances. This may cause se-
vere damage to your audio equipment!