Trimble Outdoors 58052-00 Benutzerhandbuch

Copernicus GPS Receiver 1 0 3

COPERNICUS REFERENCE BOARD 1 0

Reference Board Jumper Table

Table 10.2

Copernicus Reference Board Jumper Table

* See Copernicus Reference Board Schematics in this chapter.

Note – See

Table 3.1

for pin numbers.

indicates pin 1.

Reference Designator Name

Description

RF Input

MCX Jack (Female Connector)50 Ohms
unbalanced

XRESET

Normal Operation: Jumper in place (connects
XRESET to VCC)

Reset Operation: Removing the Jumper and
asserting pin 2 of J4 low for greater than 100 usec
resets the unit. *Switch SW1 can also reset the
unit. Please see below.

SW1

Reset Switch

Press the button resets the unit.

VCC

Normal Operation: Jumper in place (Applies
VCC to unit)

Test Mode: Jumper may be removed and ampere
meter may be inserted for current measurement.

Vback

Normal Operation: Jumper in place.(Applies
VBack to unit). The user can use VCC as the
STANDBY Supply.

8-Pin Header

See Table 10 for Reference Board pin Description.

PPS

Normal Operation: Jumper in place.(It outputs
PPS at pin 9 of both DB9 connectors of the Starter
Kit through J7 pin 6 of the Reference Board).

J9-J21

Reserved

J25

Reserved

Normal Operation: No Jumper (Run Mode).

J27

Reserved

J28

XSTANDBY

Normal Operation: Jumper between pins 1 and
2 of the jumper J28 (Run Mode). *

Standby Mode: Jumper between pins 2 and 3 of
J28. *For external control, Jumper may be
removed and pin 2 of the jumper can be
externally controlled, e.g. via a host processor.

J22-24

Spare

Spare driver transistor

J26

Antenna
Power

Normal Operation: Jumper in place.(Active
antenna powered from VCC).If a separate power
supply is desired for active antenna, jumper may
be removed and an external antenna power can
be applied to pin 2 of J26. *