Trimble Outdoors 58052-00 Benutzerhandbuch
6 RF LAYOUT CONSIDERATIONS
7 4 Copernicus GPS Receiver
•
To a lesser extent, PCB copper thickness (T) and proximity of same layer
ground plane.
ground plane.
Figure 6.2
PCB Microstrip Topology
Table 6.1
shows typical track widths for an FR4 material PCB substrate (permittivity
ε
r
of 4.6 at 1.5 GHz) and different PCB thickness. One ounce copper is assumed for
the thickness of the top layer. If a Multi layer PCB is used, the thickness is the
distance from signal track to nearest ground plane.
distance from signal track to nearest ground plane.
Table 6.1
Typical Track Widths for an FR4 material PCB Substrate in Microstrip
Topology
Topology
Microstrip Design Recommendations
It is recommended that the antenna connection PCB track be routed around the
outside of the module outline, kept on a single layer and have no bends greater than
45 degrees. It is not recommended, for production reasons, to route the track under
the module.
outside of the module outline, kept on a single layer and have no bends greater than
45 degrees. It is not recommended, for production reasons, to route the track under
the module.
Substrate Material
Permittivity
Substrate Thickness
H (mm)
H (mm)
Track Width
W (MM)
W (MM)
1.6
2.91
1.2
2.12
1.0
1.81
FR4
4.6
0.8
1.44
0.6
1.07
0.4
0.71
0.2
0.34