Troy-Bilt 769-06304 Benutzerhandbuch

: 

Battery posts, terminals, and related accessories 

contain lead and lead compounds, chemicals known 

to the State of California to cause cancer and 

reproductive harm. Wash hands after handling.

When attaching battery cables, always 

connect the POSITIVE (Red) wire to its terminal first, 

followed by the NEGATIVE (Black) wire.

For shipping reasons, both battery cables on your equipment 

may have been left disconnected from the terminals at the 

factory. To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The 

negative battery terminal is marked Neg. (–).

Remove the plastic cover, if present, from the positive 

1. 

battery terminal and attach the red cable to the positive 

battery terminal (+) with the bolt and hex nut. See Fig. 3-1.
Remove the plastic cover, if present, from the negative 

2. 

battery terminal and attach the black cable to the negative 

battery terminal (–) with the bolt and hex nut. See Fig. 3-1.

Position the red rubber boot over the positive battery 

3. 

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown 

on top/side of battery, charge the battery as instructed in the 

Maintenance section your Operator’s Manual prior to operating 

the tractor.

Make sure the riding mower’s engine is 

off, remove the ignition key, and set the parking 

brake before removing the shipping brace. Refer to 

the Controls and Features section for instructions on 

how to set the parking brake.

Locate the shipping brace, if present, and accompanying 

• 

warning tag found on the right side of the mower, between 

the discharge chute and the cutting deck. See Fig. 3-2.
Place the deck lift lever in the highest cutting position. 

• 

Refer to Setting the Cutting Height in the Operation 

section of this manual.

While pushing the discharge chute towards the machine 

• 

with your left hand, remove the shipping brace with your 

right hand by grasping it between your thumb and index 

finger and rotating it clockwise.

The shipping brace, used for packaging 

purposes only, must be removed and discarded 

before operating your riding mower.

The mowing deck is capable of 

throwing objects. Failure to operate the riding 

mower without the discharge cover in the proper 

operating position could result in serious personal 

injury and/or property damage.