Snapper 11305 Benutzerhandbuch

 

2.1.9.  Check the AC electrical outlet that will be 
used and make sure it is a polarized outlet. The 
machine has a polarized plug (one blade of plug is 
wider than the other) that will accept a polarized 
extension cord. The extension cord will fit into a 
polarized outlet (receptacle) only one way. If plug 
does not fit fully into your outlet, reverse the plug. If 
it still does not fit, contact a qualified electrician to 
install a proper polarized outlet. DO NOT modify or 
change this polarized plug in any way. 

(Go to Page 9 for Electric Start Models) 
2.2.1. ENGINE  
1.  Turn fuel shut off valve to the “ON” position. See 
Figure 2.3. 

 

 

 

2.  Insert key into ignition switch. See Figure 2.4. 
3.  Move choke control to the choke, “ON” position. 
See Figure 2.4. 
4. Move engine speed control to the “FAST” 
position. See Figure 2.4. 
5. Push primer button three times to start a cold 
engine.  NOTE: Do not use primer button to start 
warm engine. See Figure 2.4. 

 

IMPORTANT:  Stop the auger/impeller and wheel drive 

by releasing the auger/impeller and wheel drive control 
levers. Stop the engine by moving the engine speed 
control to stop or removing the key from the switch. 
 
 
 
 

 

 

 

6.  Pull rope start handle to crank engine. 
7. After engine starts, move the choke control to 
the no choke, “OFF” position. Allow a brief warm-up 
until engine runs smooth. 

 

(Continued on Next Page)