Epson DFX-5000+ Benutzerhandbuch

If the printer still does not print, disconnect the printer from

the computer and try the self test described in Chapter 1. If the

self test works properly, the printer is working and the

problem probably lies in the computer, the software, or the

cable. If the self test does not work, contact your Epson dealer.

The printer may be out of paper. Check the paper supply.

The paper may be jammed. Remove the jammed paper and

reload. Then press the PAUSE button. See the sections on

loading paper in Chapter 2.

The ribbon may be jammed. This problem is usually caused by

too much slack or a worn ribbon. See Chapter 1 to tighten the

ribbon or the section on replacing the ribbon later in this

chapter.

The top cover may be open. If the top cover is opened during

printing, the printer beeps four times and stops printing. To

resume printing, close the top cover and press the PAUSE

button.

If the printer stops and the beeper sounds, turn the printer off

and check for paper jams or other problems. Turn it back on

and try to print again. If the printer beeps again and does not

print, take it to a qualified service person.

If all the text is printed on the same line, no line feed command

is being sent at the end of each line of text. Turn DIP switch 2-3

on.

If the printer is inserting extra blank lines between lines of text,

extra line feed commands are being sent. Turn DIP switch 2-3