Edelbrock r09431 Benutzerhandbuch
©2006 Edelbrock Corporation
Rev. 3/06 - BC/mc
Rev. 3/06 - BC/mc
Catalog #R09430, #R09431
Brochure #63-0490
Page 1 of 2
Front Brake Hose Kit
for 2004-2006 Yamaha Rhino
Catalog #R09430, #R09431
INSTALLATION INSTRUCTIONS
1.
Remove factory brake hoses, noting routing. NOTE: Factory cable tie-style hose retainers are re-usable - pull tab
on locking end of tie away from strap to release
on locking end of tie away from strap to release
(See Fig. 1).
2.
Route Russell upper hose similar to factory. Mount T-block end onto chassis in factory location. (NOTE: Do not
install banjo onto master cylinder until lower hoses are installed). Insert supplied bushing into T-block so that
flange is between mounting surface and T-block
install banjo onto master cylinder until lower hoses are installed). Insert supplied bushing into T-block so that
flange is between mounting surface and T-block
(See Fig. 2).
Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call
our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or
e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.
our Technical Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or
e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.
INSTALLATION INSTRUCTIONS
IMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.
Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).
Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).
Fig. 1
Fig. 2
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.