Troy-Bilt c3x-d3x Benutzerhandbuch

The cutting height adjustment lever is located above the left 

rear wheel. To adjust the cutting height, refer to the “Assembly & 

Set-Up” Section.

Your mower’s deck is equipped with a water port on its surface 

as part of its deck wash system. Use the deck wash to rinse grass 

clippings from the deck’s underside.

Your mower is shipped as a mulcher. To discharge the grass 

clippings to the side instead, follow the instructions in the 

“Assembly & Set-Up” section to attach the side discharge chute.

Keep hands and feet away from the 

chute area on cutting deck. Refer to warning label 

on the unit.

The electric start ignition switch is located on the right side of 

the upper handle. It is used only for the electric starter.

The blade control is attached to the upper handle of the mower. 

Depress and squeeze it against the upper handle to operate the 

unit. Release it to stop engine and blade.

This blade control is a safety device. 

Never attempt to bypass its operations.

The drive controls are located on top of the upper handle and are 

used to engage the drive. Squeeze the right, left, or both right 

and left controls against the upper handle to engage the drive; 

release it/them to slow down or stop mower from propelling.

The speed control is located on the variable speed control 

housing on the upper handle. This control is used to select the 

forward speed of the mower. See Figure 4-1 inset.
IMPORTANT: Move the speed control only when the engine is 

running. Changing the speed control setting with the engine off 

can damage the mower.