HP Compaq KB-9965 311059-B41 Benutzerhandbuch

Observe the following DIMM configuration requirements when installing DIMMs: 

• 

• 
• 
• 

• 
• 
• 

• 

• 

Use only industry-standard PC1600 registered DDR SDRAM DIMMs in 256-MB, 
512-MB, 1-GB, and 2-GB capacities. 

Install DIMMs in pairs, one bank at a time. 

Be sure that both DIMMs in a bank are the same capacity. 

Be sure that bank A is populated. 

 

  HP recommends that you use only HP DIMMs. Third-party DIMMs may have additional 

installation requirements. For information about third-party DIMM installation requirements, refer to the 

HP Advanced Memory Protection white paper at www.hp.com. 

 

  You must power down the server before installing additional DIMMs. 

 

  Follow all DIMM configuration requirements carefully. If the DIMMs are not configured 

properly, you receive an error message during POST. 

The server supports three types of optional Advanced Memory Protection: 

Online spare memory 

Single-board mirrored memory 

Hot-plug mirrored memory 

Each type includes Advanced ECC protection. 

In addition to the DIMM configuration requirements for advanced ECC memory, observe the 
following DIMM configuration requirements when installing DIMMs for online spare 
memory: 

Bank D is the online spare bank and must be populated when the server is configured for 
online spare memory. 

DIMMs installed in the online spare bank must be of equal or greater capacity than each 
of those in the remaining banks.