AstroStart 2205a Benutzerhandbuch

Press 

 and 

 buttons simultaneously.  

This function sounds the horn (short melody) and flashes the parking lights so you can locate your vehicle in a large 
parking lot.  

The remote can be programmed to be used in silent mode.    
Refer to the following table to select the necessary command.  
The mode is de/activated the same way (except for the alarm and the pre-shock).  

The keypad of your remote can be locked to prevent any unwanted commands to be sent 
to your vehicle. 
The mode is de/activated the same way. Refer to the following table to select the 
necessary command. 

To activate the panic mode, press on the buttons shown in table 
simultaneously. 
This command activates all deterrents that are connected to the system, 
parking lights, horn, siren and dome light for 30 sec. 

 or 60 sec. 

 

depending on programming made during installation.  
Panic mode is used to attract attention if you are experiencing difficulties.  
If you are inside the vehicle when Panic Mode is activated, press on the brake pedal to lock doors (optional connections 
required) and neutralize antitheft (60 sec. if doors were already locked). As long as the cycle is not over, applying the brakes 
resets the sequence from the beginning every time.  
This command will not be executed if engine is kept running by ignition key. Use the stop command to abort panic mode. 

When a remote start attempt fails, it is possible to determine what caused the failure to start. 

Press the 

 and  

 buttons simultaneously. The number of times the parking lights flash corresponds to the start 

fail code. 
The table below lists the various start fail codes. 

Module has received a Stop command (remote or timer). 

Brakes were applied during or after start sequence or module overload occurred. 

Stopped by alarm. 

Engine does not crank when starting sequence is initiated. 

Start command ignored because hood is open. 

Safety sequence not valid during start sequence. 

Start command ignored because key is in ignition (in “Run” position). 

Remote starter main switch is OFF. 

Runtime has elapsed. 

Remote starter attempted to start engine three times unsuccessfully. 

Remote starter sensed engine was already running. 

Engine is over-revving (RPM > 3000)(programmable at time of installation). 

Engine not cranking fast enough during start sequence. 

Security sequence has been invalidated by status of parking brake. 

Security sequence has been invalidated by opening of one or more doors. 

Internal failure of module. 

Module does not detect manual interface. 

Consult your dealer. 

If any of these start fail codes persist, consult your dealer. 

 > 5 sec. 

 

 

 

 

 > 5 sec. 

 

 

 

 > 5 sec. 

 or 

 > 5 sec.