Sanyo clt-u12 Benutzerhandbuch
12
Resetting to default
You can reset the phone programming to the initial factory default settings. The
default settings are:
default settings are:
Language
English
Area Code
- - -
Ringer Tone
1
Tone/Pulse Setting
Tone
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG repeatedly until “DEFAULT 1 NO” shows on screen.
3. Press CID
or
, or the 1 or 2 keys to select your choice.
4. Press FLASH/PROG again to confirm. You will hear a confirmation tone.
INITIAL PROGRAMMING
Receiving a call
When receiving an incoming call, the LED on the handset flashes, and the handset
will show caller information. *
will show caller information. *
* Note: A subscription is required from your local phone company to receive
Caller ID information on your phone. See Caller ID Features, page 16.
Caller ID information on your phone. See Caller ID Features, page 16.
1. Press TALK to answer the call.
Note: If handset is in the base cradle, remove it from base before pressing
the TALK key. Either handset 1 or handset 2 can answer the call at once.
the TALK key. Either handset 1 or handset 2 can answer the call at once.
(for CLT-U12, CLT-U22, and CLT-U32)
2. Press TALK to end your call.
Note: If you replace the handset to the base cradle or charger cradle (for
CLT-U12, CLT-U22, and CLT-U32), the handset automatically hangs up.
CLT-U12, CLT-U22, and CLT-U32), the handset automatically hangs up.
BASICS